PROCOTE equipment cleaning tips
Main system (Pump, Motor, Scales and Stand)
- Purge and drain all Procote from the entire plumbing system. Use an air purge connection if supplied, or the lowest drain location.
- Disconnect the line from the discharge side of the pump and contain product.
- Run crop oil, canola oil, or mineral oil through the pump and lines to dilute the Procote. TIP: Run the system in manual mode to get the oil through the pump and drain into a bucket.
- To help prevent rust, blow or spray off the pump and other components. Address any rust issues by removing the rust, priming, and re-painting these areas.
- If possible, ensure the power is disconnected from all components to protect from power surges while not in use. Follow automation company’s recommendations.
Agitation Equipment
- Unhook air hose and remove agitation equipment.
- Clean agitation equipment .
- Store in a dust-free, dry area.
Heat Blanket
- Remove blanket from the tote.
- Refer to heat blanket manual for cleaning.
- Refer to heat blanket manual for storage conditions
You may also be interested in:
PROCOTE Applicators
Go back to the main page.
backHEAT
How to maintain the proper (heat) temperature.
Go to HEAT tipsAGITATION
Agitate Procote before each use.
Go to AGITATION tipsTOTE TILT
Take a look at our tote tilting recommendations.
Go to TOTE TILTINGCOMPATIBILITY
Check out the Procote compatibility matrix.
Go to COMPATIBILITYORDER OF APPLICATION
Always apply oil-based product last.
Go to ORDER OF APPLICATIONUSE OLDEST PRODUCT FIRST
Tips on how to find the batch number.
Go to USE OLDEST PRODUCT FIRSTCHECKLIST
Pe-season / startup checklist.
Go to CHECKLIST